Wire harness kit for bosch ignition 900 Super Sport from 1978 on and 900 MHR up to 1982.
Finally a wire harness kit that is well made for our bevel drives. The kit comes with colored wires and coded wire diagram. All the correct male and female connectors etc are installed and ready to plug into your stock block connectors from the old harness.
So, to install the kit, remove your old harness and lay it out on the floor. Make some diagrams of which wires go in which holes, then verify which NEW wires go where, remove the old and snap in the new. EASY!
All wires are inside tubing so you can then take the harness and install it, and add, subtract or move specific wires as req'd for your specific application.
