Fuel Tap - Brev-Orlandi [10mm x 1.0] All Ducati Singles (except 450)
FINALLY! A 10mm stainless bottom outlet fuel tap for Ducati singles that looks like the old originals..... On / Off / Reserve includes gasket for mounting
IMPORTANT: The direction that the handle points (alignment of tap) is totally determined by the stacked height of the washers added. So, you may find yourself needing 1 new washer, or 1 new + 1 old, or 2 new etc. What we do is put on 1 new washer and HAND TIGHTEN the tap to check alignment. If it is less than a quarter turn away from being perfect BY HAND then you are good. We sometimes need to sand down the thickness of a washer for perfect alignment.
NOTE: Do not use a wrench to tighten up the tap if you have to turn it more than a quarter turn as you most likely will strip out the threads or snap the threaded part of the tap off! See note above regarding stacked height of fiber washers!
Rely on the THREAD SEALANT to seal up your system, rely on the thickness of the WASHERS to align the direction of your taps.
I HIGHLY RECOMMEND you purchase "1 fuel tap & 2 fiber washers & thread sealant" so that you have everything you need to install these correctly.
E-mail to a friend
Fuel Tap - Brev-Orlandi [10mm x 1.0] All Ducati Singles (except 450)