This is a used gas tank from a Darmah that has been modified for clearance for a Lucas Rita ignition setup. Look at the lower rear right side to see the rounded cutout. I see that all the metal work has been completed and all seams are welded up. No idea if it holds gas or not. If I was going to use it I would first test it with water and if it has a pin hole, either weld it there or use JB Weld to seal from the outside and pur in some POR15 on the inside to seal it up there. Besides that, the tank itself is dent free, original factory red paint and the inside of the tank only has light rust spots as you see but no flakes.
Because of the work that will be involved to use this tank I am offering it up at under half the cost I normally get for Darmah tanks...