This is a slick little adapter kit we have made up, you can order just the rubber and steel tube with 2 clamps as shown, or get the adapter kit plus an air filter for it or, the adapter kit with it's filter plus either another PHF or PHM sized filter for your front carb as well. Choose whatever you need in the ordering choices to the right.
This will fit on all Darmah, 860 and 900 GT/S as well as all 750 models. PHF or PHM carbs, doesn't matter.
Well we finally got another run of these done. A seemingly endless project to get the rubber elbow and steel tube made up.. The kit above can be installed on the rear carb of any bevel drive to allow an air filter to be installed and still retain your side covers. The rubber elbow slips over the inlet portion of your Dellorto carb and is clamped on using the provided clamp. The powdercoated steel tube slides into the other end of the rubber elbow, then you install a small cone type air filter such as what is shown on the other end of the steel tube. Each end of the steel tube is barbed so it will not slip or slide out of the rubber elbow or air filter once clamped in place.
Install your side cover and VOILA - you are done.