Wire harness kit for 1000cc Desmo Replica [MHR] & Darmah.
Finally a wire harness kit that is well made for our bevel drives. The kit comes with colored wires and coded wire diagram. All the correct male and female connectors etc are installed and ready to plug into your stock block connectors from the old harness.
So, to install the kit, remove your old harness and lay it out on the floor. Make some diagrams of which wires go in which holes, then verify which NEW wires go where, remove the old and slip in the new. EASY! All wires are inside tubing so you can then take the harness and install it, once you have added, subtracted or moved any wires per your application as req'd.
NOTE: This kit has been successfully installed on SD900 and SSD900 Darmah bikes with a couple small modifications having to do with the starter switch and relay only....